• Optimum processing conditions at +15°C to +25°C, relative humidity 40% to 75%, material temperature +15°C to +25°C
• Do not apply to surfaces exposed to hot or strong sunlight, as the applied coating may dry too quickly. Do not apply if rain is expected within 3 hours of application.
• If in doubt, create a test area to determine compatibility, adhesion and appearance. The results may vary depending on the type of wood, especially with oily, colour- intensive and resinous woods.
• Shake the contents well.
• Transfer material to a LOBA varnish bucket before applying.
• Avoid drops falling on the surface, smooth out any drops directly with a brush.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.

Thinner / Mixing

The product is ready for use and must not be reduced!

Application tool / application rate

LOBA oil brush, soft brush / 100-120ml/m². Actual material consumption may vary depending on the type of wood, wood moisture and the weathering condition of the surface. With strongly weathered surfaces, a significantly higher material consumption must be expected.

Drying time

• Drying 1 hour. Wait for complete drying

Preparation:

Please refer to the LOBA DeckDegrayer technical information for optimal surface pretreatment.

Processing:

• surface must be dry immediately before application
• Apply one layer of LOBA DeckPrepare.
• Drying 1 hour. Wait for complete drying
• Then apply LOBA DeckOil / Color or LOBA DeckFinish Color according to the Technical Information.
• To maintain the visual value of the decking, we recommend an annual basic cleaning and recoating of the decking.

Suitable product combinations

Systems recommended as a follow-up treatment

• LOBA DeckOil & DeckOil Color
• LOBA DeckFinish Color

Important information

For colour intense wood species in combination with LOBA DeckOil (especially transparent), make sure that the material is applied evenly. Apply material in grain direction board by board and avoid overlapping areas, these can show.