• Remove any loose dirt and dust in advance using a vacuum, brush or mop.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.
• Shake the contents well.

Thinner / Mixing

Water.

Application tool / application rate

LOBA mop. On large areas, use a suitable flat wiper mop or a scourer-vacuum machine. Depending on the application, add approx. 20 ml - 1 l to a bucket with 10 l of water, sufficient for 100 m².

Drying time

• Approx. 60 min.

Application:

Initial care

If initial care with a dispersion care product such as LOBA ParkettCare is not possible, mix 1l of Refresh with 10l of water and apply it to the end-of-installation or stripped flooring. The surface can be polished after drying.

Maintenance cleaning (manual):

Add 50ml Refresh to 10l water and apply it to the flooring with a wiper mop. Allow any residual moisture to dry.

Maintenance cleaning (machine):

Add 25ml Refresh to 10l water and apply it to the flooring with a scourer-vacuum machine. Do not vacuum up the liquid straight away so that the residual moisture is able to dry on the surface and achieve an adequate degree of care.

Note:

The surface must not be flooded with cleaning solution. Using too much water and allowing the product to work for too long can cause swelling of parquet, wooden and cork flooring and must therefore be avoided.

Stripping:

Refresh can be removed again after stripping with LOBA CareRemover. For details, see the product's technical information.