- For professional use only!
- BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
- For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
- Sand and prepare floors according to NWFA guidelines.
- ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
- Shake material well before use.
- Do not thin. Do not add water.
- Do not apply at temperatures below 55°F (13°C). Make sure material is at room temperature. Always maintain adequate ventilation during all phases of the coating and drying process.
- Apply evenly at the recommended coverage rate. Avoid streaks, puddles, and lap marks.
Mix in:
- Shake up LOBA SlipResist and finish.
- For 2K finishes, add LOBA SlipResist to finish and shake vigorously before adding hardener. This will make it easier to mix partial quantities if needed. Mass with additive has a storage stability of 14 days.
- Add one container of 3 fl.oz. to 1 gal. of finish.
- Attention: In order to ensure the slip resistant properties, the additive quantities must be exactly observed.
- Shake combined materials thoroughly.
- Apply 2K finish mixed with LOBA SlipResist within the specified working time. Longer stability is not guaranteed.
Suitability:
Can be combined with approved finishes. The application properties of the finish, product compatibility and drying time remain unchanged. Please observe the technical information of the corresponding finish.
Achieves slip resistance according to ASTM D 2047-17 and DIN EN 16165:2021-12 with the following finishes:
Finish Before S.R. With S.R. DIN EN 16165 ___________________________________________________________________
EasyFinish 0.67 0.79 R10
2K Duo 0.65 0.74 R10
2K InvisibleProtect 0.65 0.75 R11
2K Supra A.T. 0.73 0.79 R10
Note: To achieve an R11 surface with 2K InvisibleProtect in combination with SlipResist, a 3 coat application is required.
The first coat can also be replaced by a sealer.For professional use only!
Compatibility
When this product is used in combination with other LOBA products the technical information of these products must be followed. Refer to the Technical Data Sheets. LOBA cannot guarantee the suitability of products other than LOBA or the bond of the existing coating to the substrate.
Contact
