• Avoid lapmarks: The darker the substrate, the higher the risk of lapmarks. Material must not be poured on the floor. Use LOBA finish bucket and apply directly with recommended applicator.
• The use in satin finishes reduces the risk of lapmarks.
• Preferably use in at least two layers.
• Apply LOBA products with Whitener as evenly as possible, avoiding puddles and overlaps. Ensure an even application rate.
• The color effect of LOBA Whitener depends on the type of wood. In order to assess the achievable color shade and the overall optical effect, we recommend to prepare a color sample on the original wood.
• Wood species with water-soluble wood components (e.g. tannic acid) whose intensity can vary within a surface can influence the effect of LOBA Whitener.
• For professional use only!
• BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
• For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
• Sand and prepare floors according to NWFA guidelines.
• ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
• Shake material well before use.

Mixing:

• Shake LOBA Whitener and finish well.
• Add just before application.
• Add a maximum of one container of 1x80ml to 1 Gal. of finish.
• Shake or stir in thoroughly (also possible mechanically with a LOBA paint mixer).
• In the case of two-component systems, LOBA Whitener is added after the hardener is worked into the mass!
• 1K finish mixed with LOBA Whitener must be applied within 24 hours, 2K finishes within the indicated application time. Longer stability is not guaranteed.
  

Suitability:

Can be combined with all LOBA water-based finishes and sealers. The application properties of the finish, its product combinability, and the drying time remain unchanged. Refer to the Technical Data Sheet of the corresponding finish.

For professional use only!

Compatibility

When this product is used in combination with other LOBA products the technical information of these products must be followed. Refer to the Technical Data Sheets. LOBA cannot guarantee the suitability of products other than LOBA or the bond of the existing coating to the substrate.